Muratec F-565 Specifikace stáhnout pdf (Strana 374)

100

101

6-2

5. Reattach the PCB NGP and the covers.

6. Plug the power cord and turn the machine on.

7. Initialize the memory module by pressing <Setting>, <*>, <1>, <6>, and [Yes].

Note: This setting ( [DRAM clear] ) will erase all of stored documents in the machine’s memory.

8. Perform the memory test ( [DRAM clear] ) by the following procedure.

1) Press <Setting>, <*>, <1>, <1>, then select [DRAM Check] .

2) Use the numeric keys and one-touch keys [01] through [06] to enter Hex code (00 to FF), and

press <Start>.

Use the sharp key (#) to enter A, B, C, D, E and F. See table below.

A B C D E F

#, 0 #, 1 #, 2 #, 3 #, 4 #, 5

3) Enter RAM check area by number. (See table below)

Press Check area

0 All DRAMs

1 The standard memory on the main control board

2 The ﬁrst half of the 32MB Optional Memory PCB

3 The second half of the 32MB Optional Memory PCB

4) Press <Start>.

5) The machine shows the checked result. Press <Reset> to go back to the standby mode.

9. Print the “Fax Settings List” by pressing <Setting>, [List], [Setting List], [Fax Setting], and [Yes] to

see the memory amount becomes 40960 KB (40 MB).

10. Turn the machine off.

11. Reattach the covers and the harness.

1 2 ... 369 370 371 372 373 374 375 376 377 378 379 ... 382 383

Komentáře k této Příručce

Žádné komentáře

Muratec F-565 Specifikace Strana 374

Komentáře k této Příručce

Související produkty a manuály pro Multifunkční zařízení Muratec F-565